Surface Gauges and Testers arrow Starrett Compact Surface Roughness Tester (Discontinued)

Compact Surface Roughness Tester (Discontinued)



Part#: SR100
Supplier: Starrett
Calibration Certificate: is available at extra cost
Surface Roughness Tester (1,53 MB)
Photo Gallery - click any photo to enlarge

This Starrett Compact Surface Roughness Tester model SR100 has been discontinued. Information shown here is for reference only.  The Starret SR100 has been replaced by Simple Surface Roughness Tester model SR160

features

  • Large LCD window
  • Measures Ra at the touch of a button
  • In addition to basic roughness parameters Ra and Rz, also measures advanced Rp, Rv and Rt parameters
  • Five second cycle time
  • Result saved until the next measurement is taken
  • Switches between inch and metric mode without remeasuring
  • Use right out of the box – little or no operator training required
  • Automatic shut-off after five minutes of inactivity
  • Configured with the most common industrial settings to ensure correlation between multiple operators (see specifications)
  • Simple and reliable calibration routine
  • Uses standard off-the-shelf calculator type batteries (CR2450) with a minimum life of 5, 000 measurements
  • Includes SR100 two-piece assembly, calibration standard, batteries, operation guide and a carrying case
  • SR100 uses an infra-red (IrDA) link between the upper and lower units to provide remote, cable free operation up to a distance of 40"

Starrett SR100 Video presentation

Specs

  • Accuracy (in): 5% of reading + 4µin
  • Cutoff Lengths: 0.03" ± 15%
  • Filter: 2CR
  • Measuring Range: Ra: 1600µin Rz, Rv, Rp, Rt: 7800µin
  • Pick-up Stylus: Piezoelectric
  • Roughness Parameter: Ra, Rz, Rv, Rp, Rt
  • Tracer Tip: Diamond, Radius 200µin
  • Tracing Length: 0.2"
  • Tracing Speed: 0.08"/sec 

Need to have this new Starrett SR100 Compact Surface Roughness Tester (Discontinued) calibrated? While this gauge has passed a quality control check, having a calibration certificate for surface gauges and testers might be required by your quality control system. Digital Measurement Metrology (owner of ProcessInstruments.ca) is a canadian metrology company with more than 25 years of experience. Our Brampton, Ontario based calibration lab has one of the most comprehensive ISO 17025 accredited calibration scope in Canada.

Do you have an old Starrett gauge to be calibrated? We might be able to calibrate Starrett surface gauges and testers (Starrett SR100 or a different model) and provide an ISO, NIST traceable calibration certificate. Please contact our metrology lab for more info.

Ordering info

SKUDescriptionUnitPriceIn Stock
SR100Starrett Compact Surface Roughness Tester (Discontinued)piece 0

More Recommendations for Surface Gauges And Testers